AD: Honda Aircraft Company LLC Airplanes | Aero-News Network
Aero-News Network
RSS icon RSS feed
podcast icon MP3 podcast
Subscribe Aero-News e-mail Newsletter Subscribe

Airborne Unlimited -- Most Recent Daily Episodes

Episode Date

Airborne-Monday

Airborne-Tuesday

Airborne-Wednesday Airborne-Thursday

Airborne-Friday

Airborne On YouTube

Airborne-Unlimited-05.12.25

Airborne-NextGen-05.06.25

AirborneUnlimited-05.07.25

Airborne-AffordableFlyers-05.08.25

AirborneUnlimited-05.09.25

Sun, Mar 20, 2022

AD: Honda Aircraft Company LLC Airplanes

AD 2022-05-13 Prompted By A Report Of In-Flight Smoke And Fire That Initiated From The Windshield Heat Power Wire Braid

The FAA is adopting a new airworthiness directive (AD) for certain Honda Aircraft Company LLC (Honda) Model HA-420 airplanes.

This AD was prompted by a report of in-flight smoke and fire that initiated from the windshield heat power wire braid. This AD requires incorporating temporary revisions into the airplane flight manual (AFM) and the quick reference handbook (QRH) that modify procedures for windshield heat operation until the affected windshield assemblies are replaced. The FAA is issuing this AD to address the unsafe condition on these products. This AD is effective April 18, 2022. 

Supplementary Information: The FAA issued a notice of proposed rulemaking (NPRM) to amend 14 CFR part 39 by adding an AD that would apply to certain serial-numbered Honda Model HA-420 airplanes. The NPRM published in the Federal Register on September 30, 2021 (86 FR 54126). The NPRM was prompted by a report of in-flight smoke and fire that initiated from the windshield heat power wire braid on a Honda Model HA-420 airplane.

An investigation identified that certain Honda Model HA-420 airplanes could have a severed windshield heat power wire braid from installation of the windshield heat wiring during manufacture. The severed windshield heat power wire braid could cause arcing that ignites the wire sheathing and sealant and the windshield acrylic. This condition, if not addressed, could lead to cockpit smoke and fire. In the NPRM, the FAA proposed to require incorporating temporary revisions into the AFM and the QRH that modify procedures for windshield heat operation until the affected windshield assemblies are replaced. The FAA is issuing this AD to address the unsafe condition on these products.

FMI: www.regulations.gov

Advertisement

More News

Aero-News: Quote of the Day (05.13.25)

“...no entity, whether a division of government or a private company or corporation, may use information broadcast or collected by automatic dependent surveillance-broadcast >[...]

IAG Orders 76 Boeing, Airbus Airliners

Growth And Fleet Replacements On The Way International Airlines Group, a joint holding company between British and Spanish air carriers, announced it has ordered up to 76 new Boein>[...]

FAA Shuts Down ATC Oversight Review Amid Scrutiny

Expert Analysts Scrutinized the FAA’s Oversight of ATC Organization In a move that appears somewhat mistimed (at best…tone-deaf at worst), the Federal Aviation Adminis>[...]

Montana’s ADS-B Privacy Bill Signed Into Law

Community Continues to Push Back Against ADS-B-Facilitated Landing Fees On May 8, a bill to limit frivolous use of ADS-B tracking data was signed into law by Montana Governor Greg >[...]

Newark Falls Victim to More Equipment Outages

Duffy Shares Plans to Scale Back Flights at Newark Liberty International After a ‘telecommunications issue’ with Philadelphia TRACON brought yet another string of delay>[...]

blog comments powered by Disqus



Advertisement

Advertisement

Podcasts

Advertisement

© 2007 - 2025 Web Development & Design by Pauli Systems, LC