Security Video Shows Erratic Flight In Utah Accident | Aero-News Network
Aero-News Network
RSS icon RSS feed
podcast icon MP3 podcast
Subscribe Aero-News e-mail Newsletter Subscribe

Airborne Unlimited -- Most Recent Daily Episodes

Episode Date

Airborne-Monday

Airborne-Tuesday

Airborne-Wednesday Airborne-Thursday

Airborne-Friday

Airborne On YouTube

Airborne-Unlimited-05.19.25

Airborne-NextGen-05.20.25

AirborneUnlimited-05.21.25

Airborne-AffordableFlyers-05.22.25

AirborneUnlimited-05.23.25

Tue, Jun 12, 2012

Security Video Shows Erratic Flight In Utah Accident

NTSB Preliminary Report Describes Acceleration In Ground Effect, Rapid Climb, Descent

The NTSB's preliminary report on an accident in St. George, UT, which resulted in the fatal injury of four people aboard a Cessna 172 describes footage from a security video camera which shows the airplane accelerating in ground effect, rapidly climbing, and then rapidly descending before impacting terrain. The accident occurred just before 0130 local time, and the condition of the pilot won't be known until the board's factual report is released.

NTSB Identification: WPR12FA230
14 CFR Part 91: General Aviation
Accident occurred Saturday, May 26, 2012 in St. George, UT
Aircraft: CESSNA 172S, registration: N953SP
Injuries: 4 Fatal.

This is preliminary information, subject to change, and may contain errors. Any errors in this report will be corrected when the final report has been completed.

On May 26, 2012, about 0120 mountain daylight time, a Cessna 172S, N953SP, collided with terrain shortly after departing from St. George Municipal Airport, St. George, Utah. Diamond Flying LLC was operating the airplane under the provisions of 14 Code of Federal Regulations (CFR) Part 91. The commercial pilot and three passenger sustained fatal injuries; the airplane sustained substantial damage. The local personal flight was departing from St. George with a planned destination of Mesquite, Nevada. Visual meteorological conditions prevailed, and no flight plan had been filed.

A review of the recorded security camera footage at the airport revealed that the airplane could be seen in the nighttime conditions by the blinking left-wing strobe light and the navigation light mounted on the tail. The airplane appeared to depart from runway 19 and maneuver at a low altitude for the length of the runway while increasing its airspeed. Near the end of the runway, the airplane began a rapid ascent and continued out of the view of the camera. After about 7 seconds, the airplane reappears further down the frame in a rapid descent.

The accident site was located in the hard dirt area (the southerly primary surface) adjacent to the departure end of runway 19. Situated on the level terrain, the airplane came to rest in an inverted attitude and was oriented on a 315-degree magnetic bearing. The main wreckage, which consisted of a majority of the airframe and engine, was located about 525 feet from the edge of the runway's center point.

The first identified point of impact was a ground scar impression about 40 feet from the main wreckage that dimensionally and geometrically resembled the wings with a crater-like impression in between. The span of the ground disturbance was about 36.5 feet, with red lens fragments located near the east side and green fragments on the westerly side; the airplane's wingspan was 36.1 feet. Imbedded in the center crater was a portion of a propeller blade and the nose wheel. In the debris field from the ground scar to the main wreckage was the oil sump, the propeller, and engine accessories.

A routine aviation weather report (METAR) generated by an Automated Surface Observation System (ASOS) at the airport, indicated that about 5 minutes prior to the accident the conditions were as follows: wind was from 260 degrees at 9 knots; temperature 66 degrees Fahrenheit; dew point 28 degrees Fahrenheit; and altimeter 29.60 inHg.

FMI: www.ntsb.gov

Advertisement

More News

ANN's Daily Aero-Term (05.29.25): Terminal Radar Service Area

Terminal Radar Service Area Airspace surrounding designated airports wherein ATC provides radar vectoring, sequencing, and separation on a full-time basis for all IFR and participa>[...]

ANN's Daily Aero-Term (05.30.25): Very High Frequency (VHF)

Very High Frequency (VHF) The frequency band between 30 and 300 MHz. Portions of this band, 108 to 118 MHz, are used for certain NAVAIDs; 118 to 136 MHz are used for civil air/grou>[...]

Aero-News: Quote of the Day (05.30.25)

“From approximately November 2021 through January 2022, Britton-Harr, acting on behalf of AeroVanti, entered into lease-purchase agreements for five Piaggio-manufactured airc>[...]

Airborne 05.23.25: Global 8000, Qatar B747 Accepted, Aviation Merit Badge

Also: Virtual FLRAA Prototype, IFR-Capable Autonomous A/C, NS-32 Crew, Golden Dome Missile Defense Bombardier announced that the first production Global 8000 successfully completed>[...]

ANN's Daily Aero-Linx (05.30.25)

Aero Linx: The 1-26 Association (Schweizer) The Association’s goal is to foster the helpfulness, the camaraderie, and the opportunity for head-to-head competition that is fou>[...]

blog comments powered by Disqus



Advertisement

Advertisement

Podcasts

Advertisement

© 2007 - 2025 Web Development & Design by Pauli Systems, LC