Wed, Dec 02, 2009
Flap Rigging Indicated In At Least One Accident
The FAA has issued a Special Airworthiness Information
Bulletin (SAIB) regarding an airworthiness concern on Hawker
Beechcraft Model 60 (Duke) Series twin-engine powered
airplanes.
In at least one instance, a Hawker Beechcraft Model 60 (Duke)
airplane impacted terrain after attempting to takeoff, which
resulted in the airplane being destroyed. The flap actuators
recovered at the crash site indicated that the left flap was fully
retracted and the right flap was fully extended, which may have
contributed to the accident. Further examination of the flap
actuators revealed evidence of torsional-induced overload on the
output shaft and corrosion on the output drive shaft subassembly,
key location, and roller bearings.
The roller bearings showed evidence of binding. Proper rigging
is essential to assure the correct operation of the flap system. If
the flap bottoms out in the flap track before the flap limit switch
deactivates the motor, it will stress the actuator, the 90-degree
output shaft, and key. Repeated cycles with this condition may
result in fractures in the key and output shaft.
The internal parts of both actuators were covered with a blend
of oil and bearing grease. While it is normal to have grease and
oil present in the actuator, the mixture of grease and oil on the
actuator screw may be an indication that grease had been used to
lubricate the actuator screw rather than oil. The Beechcraft Duke
Model 60 Series Maintenance Manual (P/N 60-590001- 25) requires the
actuator be lubricated with MIL-L-6086 Grade M oil (gear oil) every
1,000 hours. In addition, it requires that the actuator be replaced
or overhauled every 2,000 hours. The Hawker Beechcraft Duke Model
60 Component Maintenance Manual (P/N 60-590001-27) requires the
bearings to be packed with MIL-G-23827 grease before the actuator
is reassembled.
The FAA recommends that owners, operators, and maintenance
personnel thoroughly review, understand, and adhere to the
information published in the documentation identified above to
maintain the flap system in an airworthy condition. Special
emphasis should be placed on the correct flap system rigging,
actuator overhaul and inspection criteria, and the use of the
proper lubricants.
Failure to do so can have serious consequences.
More News
Takeoff Roll The process whereby an aircraft is aligned with the runway centerline and the aircraft is moving with the intent to take off. For helicopters, this pertains to the act>[...]
“We’re proud of the hard work that went into receiving this validation, and it will be a welcome relief to our customers in the European Union. We couldn’t be mor>[...]
Also: 1800th E-Jet, Uncle Sam Sues For Landing Gear, Embraer Ag Plane, Textron Parts A friend of the family reported that Lt. Col. (Ret.) Richard Glenn Rutan flew west on Friday, M>[...]
Also: Virgin Galactic, B-29 Doc to Allentown, Erickson Fire-Fighters Bought, FAA Reauthorization After dealing with a big letdown after the unexpected decision by Skyreach to disco>[...]
"Aircraft Spruce is pleased to announce the acquisition of the parts distribution operations of Wag-Aero. Wag-Aero was founded in the 1960’s by Dick and Bobbie Wagner in the >[...]