Wed, May 07, 2014
Stems From Accident In Germany In Which Main Gear Did Not Lock Down, Airplane Damaged
The FAA has issued a Special Airworthiness Information Bulletin (SAIB) related to an airworthiness concern with Cessna Model 177RG and Reims Model F177RG airplanes. The SAIB recommends the inspection of the MLG actuator rod end bearing to ensure that cracks are not present.

In August 2012, a German-registered Cessna Model 177RG airplane made an emergency landing in Spain with the main gear not locked in the down position. No injuries were reported, but the airplane was damaged. The MLG actuator rod end bearing, Cessna part number S2049-6FG or S2049M6FG, had fractured at the location of the lubrication hole.
The FAA conducted an in-depth review of the MLG actuator failures as a result of the German incident. Our investigation found that there are approximately 878 Cessna Model 177RG airplanes listed in the FAA N-number registry ranging in age from 35 to 43 years. The result of our investigation and risk analysis show that infrequent failure of the MLG actuator on these model airplanes could result in damage to the underside of the airplane if the MLG does not extend and lock down. The SDRs reflect that adequate service information is available and being used by owners and operators to properly maintain their airplanes. As an example, several SDR reports mentioned the Cessna Service Information Letter SE79-37R1. However, we feel issuance of this SAIB will serve as notice to those owners, operators, and maintenance technicians who may not be aware of the Cessna service information.
The FAA recommendations include:
- Identify MLG actuator cracks and if cracks are present, replacement should be done to prevent the possibility of an airplane landing with the MLG not extended and locked down.
- Whether or not cracks are found replace Cessna part numbers S2049-6FG or S2049M6FG with Cessna part number S3469-1 if not previously replaced by S2426-6 per SE79-37R1.
- Comply with Cessna Service Information Letter SE79-37R1 dated December 15, 1980. Additional information is provided in Supplemental Inspection Number 32-10-01, D991-3-13 Temporary Revision Number 7, dated December 1, 2011, in Section 2A-14-03 of the Cessna Aircraft Company Model 177RG Series (1971-1975) Service Manual.
(Image from file)
More News
He Attempted To Restart The Engine Three Times. On The Third Restart Attempt, He Noticed That Flames Were Coming Out From The Right Wing Near The Fuel Cap Analysis: The pilot repor>[...]
Make Sure You NEVER Miss A New Story From Aero-News Network Do you ever feel like you never see posts from a certain person or page on Facebook or Instagram? Here’s how you c>[...]
From 2009 (YouTube Edition): Leading Air Show Performers Give Their Best Advice for Newcomers On December 6th through December 9th, the Paris Las Vegas Hotel hosted over 1,500 air >[...]
Aero Linx: NASA ASRS ASRS captures confidential reports, analyzes the resulting aviation safety data, and disseminates vital information to the aviation community. The ASRS is an i>[...]
“For our inaugural Pylon Racing Seminar in Roswell, we were thrilled to certify 60 pilots across our six closed-course pylon race classes. Not only did this year’s PRS >[...]