NTSB Prelim: Chip Light Warns Bell 407 Just Before Power Failure | Aero-News Network
Aero-News Network
RSS icon RSS feed
podcast icon MP3 podcast
Subscribe Aero-News e-mail Newsletter Subscribe

Airborne Unlimited -- Most Recent Daily Episodes

Episode Date

Airborne-Monday

Airborne-Tuesday

Airborne-Wednesday Airborne-Thursday

Airborne-Friday

Airborne On YouTube

Airborne-Unlimited-04.29.24

Airborne-Unlimited-04.23.24

Airborne-Unlimited-04.24.24 Airborne-FltTraining-04.25.24

Airborne-Unlimited-04.26.24

Mon, Dec 19, 2011

NTSB Prelim: Chip Light Warns Bell 407 Just Before Power Failure

Gulf Autorotation Into The Drink Results In No Injuries

There are few more unwelcome incidents in flight, to a help pilot, the glaring 'uh-oh' imposed by an illuminated chip light. In such circumstances, all you can and should do is get on the deck as soon as circumstances permit... before those circumstances are forced.

NTSB Identification: CEN12IA096
Nonscheduled 14 CFR Part 135: Air Taxi & Commuter
Incident occurred Thursday, December 01, 2011 in Gulf Of Mexico, GM
Aircraft: BELL HELICOPTER TEXTRON CANADA 407, registration: N435PH
Injuries: 2 Uninjured.

This is preliminary information, subject to change, and may contain errors. Any errors in this report will be corrected when the final report has been completed.

On December 1, 2011, about 1005 central standard time, a Bell 407 helicopter, N435PH, was successfully autorotated to the water following a loss of engine power while in cruise flight over the Gulf of Mexico. The helicopter was not damaged during the on water landing. The commercial pilot, and sole passenger, were not injured. The helicopter was registered to and operated by PHI, Inc., under the provisions of 14 Code of Federal Regulations Part 135 as a non-scheduled air-taxi flight. Visual meteorological conditions prevailed and a company flight plan had been filed. The flight originated from platform EC278-C, and was en route to platform EC261, both in the Gulf Of Mexico.

According to the pilot, while en route to EC261 the engine chip light illuminated. The flight was abeam platform EC278-B at the time, and the pilot elected to divert for a precautionary landing. While on the base leg to EC278-B, the pilot heard a loud whining noise followed by a loud popping noise and the helicopter began to yaw. The pilot entered an autorotation, called mayday, inflated the floats, and performed a successful water landing. The pilot and passenger were able to exit the helicopter unassisted into a life raft and were picked up within 10 minutes. The helicopter remained upright for approximately 20 minutes before overturning.

The helicopter was recovered for further examination.

FMI: www.ntsb.gov

 


Advertisement

More News

ANN's Daily Aero-Term (04.28.24): Airport Marking Aids

Airport Marking Aids Markings used on runway and taxiway surfaces to identify a specific runway, a runway threshold, a centerline, a hold line, etc. A runway should be marked in ac>[...]

Aero-News: Quote of the Day (04.28.24)

"It is extremely difficult, if not impossible, for manned aircraft to see a drone while conducting crop-enhancing and other aerial applications at low altitudes and high speeds. We>[...]

ANN's Daily Aero-Linx (04.28.24)

Aero Linx: The Skyhawk Association The Skyhawk Association is a non-profit organization founded by former Skyhawk Pilots which is open to anyone with an affinity for the A-4 Skyhaw>[...]

Aero-News: Quote of the Day (04.29.24)

“The T-54A benefits from an active Beechcraft King Air assembly line in Wichita, Kansas, where all required METS avionics and interior modifications are installed on the line>[...]

ANN's Daily Aero-Linx (04.29.24)

Aero Linx: Aerostar Owners Association The Association offers the Aerostar Owner a unique opportunity to tap an invaluable source of information concerning the care and feeding of >[...]

blog comments powered by Disqus



Advertisement

Advertisement

Podcasts

Advertisement

© 2007 - 2024 Web Development & Design by Pauli Systems, LC