AD: Austro Engine GmbH Engines | Aero-News Network
Aero-News Network
RSS icon RSS feed
podcast icon MP3 podcast
Subscribe Aero-News e-mail Newsletter Subscribe

Airborne Unlimited -- Most Recent Daily Episodes

Episode Date

Airborne-Monday

Airborne-Tuesday

Airborne-Wednesday Airborne-Thursday

Airborne-Friday

Airborne On YouTube

Airborne-Unlimited-07.07.25

Airborne-NextGen-07.08.25

AirborneUnlimited-07.09.25

Airborne-FlightTraining-07.10.25

AirborneUnlimited-07.11.25

Sat, Nov 25, 2023

AD: Austro Engine GmbH Engines

AD 2023-20-03 Prompted By Reports Of Piston Failures

The FAA is adopting a new airworthiness directive (AD) for certain Austro Engine GmbH Model E4 and E4P engines.

This AD is prompted by reports of piston failures and the determination that certain batches of pistons were manufactured with a dimensional deviation in the piston pin bore and piston diameter. This AD requires repetitive engine oil analysis for aluminum content outside the acceptable limits and, if necessary, replacement of the pistons, piston rings, con-rods assembly, and crankcase or, as an alternative, replacement of the engine core. The FAA is issuing this AD to address the unsafe condition on these products. This AD is effective December 11, 2023.

Background: The FAA issued a notice of proposed rulemaking (NPRM) to amend 14 CFR part 39 by adding an AD that would apply to certain Austro Engine GmbH Model E4 and E4P engines. The NPRM published in the Federal Register on July 14, 2023 (88 FR 45118). The NPRM was prompted by European Union Aviation Safety Agency (EASA) AD 2022–0240R1, dated December 15, 2022 (referred to after this as the MCAI), issued by EASA, which is the Technical Agent for the Member States of the European Union. The MCAI states that a manufacturer investigation into reports of piston failures determined that certain batches of pistons were manufactured with a dimensional deviation in the piston pin bore and in the piston diameter, which could cause piston failure, with consequent loss of oil, loss of engine power, and reduced control of the airplane. To address the unsafe condition, EASA issued EASA AD 2022–0240, dated December 6, 2022 (EASA AD 2022–0240), to specify repetitive oil analyses and replacement of the pistons, piston rings, con-rods assembly, and crankcase, or as an alternative, replacement of the engine core. EASA AD 2022–0240 also prohibited release to service of an airplane until receipt of the results for each oil analysis.

Since EASA AD 2022–0240 was issued, the manufacturer determined that aluminum levels outside of the acceptable limits would be found during the first oil analysis, and are unlikely to be found during subsequent oil analyses. As a result, EASA revised

EASA AD 2022–0240 and issued the MCAI to allow release to service of airplanes for a limited number of flight hours immediately after the second and subsequent oil samples are taken for analyses.

In the NPRM, the FAA proposed to require initial and repetitive engine oil analysis for aluminum content outside the acceptable limits and, if necessary, replacement of the pistons, piston rings, con-rods assembly, and crankcase, or as an alternative, replacement of the engine core. The FAA is issuing this AD to address the unsafe condition on these products.

You may examine the MCAI in the AD docket at regulations.gov under Docket No. FAA–2023–1412.

FMI: www.regulations.gov

Advertisement

More News

NTSB Final Report: Aviat A1

Airplane Bounced About 3 Ft Then Touched Back Down And Then, With No Brakes Applied, The Airplane Began Veering To The Left Analysis: The pilot entered the airport traffic pattern >[...]

ANN's Daily Aero-Linx (07.08.25)

Aero Linx: British Microlight Aircraft Association (BMAA) The primary focus within all aviation activity is SAFETY. In all aspects of our sport SAFETY must come first, whether it b>[...]

Classic Aero-TV: Fly Corvair’s Reliable Engine Alternative

From SnF25 (YouTube Edition): William Wynne Builds Practical Aircraft Engines on the Corvair Platform Seeking an affordable alternative to the traditional aircraft engine options, >[...]

ANN FAQ: Contributing To Aero-TV

How To Get A Story On Aero-TV News/Feature Programming How do I submit a story idea or lead to Aero-TV? If you would like to submit a story idea or lead, please contact Jim Campbel>[...]

Classic Aero-TV: CiES Fuel-Quantity and e-Throttle Systems Praised

From 2023 (YouTube Edition): Bridge of CiES CiES Inc. is a Bend, Oregon-based designer and manufacturer of modular embedded aircraft systems and sensors. The company’s fuel-l>[...]

blog comments powered by Disqus



Advertisement

Advertisement

Podcasts

Advertisement

© 2007 - 2025 Web Development & Design by Pauli Systems, LC