Fri, Jan 01, 2021
AD 2020-26-21 Requires A Rotating Probe Test Of All Fastener Holes Located In The Affected Area
The FAA is adopting a new airworthiness directive (AD) for certain Airbus SAS Model A350-941 airplanes.
This AD was prompted by a report that during the assembly of a certain section of the fuselage, the gaps found on self-aligning nuts for eight fasteners were out of tolerance. This AD requires a rotating probe test of all fastener holes located in the affected area for any discrepancies, an eddy current inspection of the surrounding flange for any discrepancies, a detailed inspection of certain frames for any discrepancies, and corrective actions if necessary, as specified in a European Union Aviation Safety Agency (EASA) AD, which is incorporated by reference. The FAA is issuing this AD to address the unsafe condition on these products. This AD is effective February 3, 2021.
Supplementary Information: The EASA, which is the Technical Agent for the Member States of the European Union, has issued EASA AD 2020-0109, dated May 15, 2020 (EASA AD 2020-0109) (also referred to as the Mandatory Continuing Airworthiness Information, or the MCAI), to correct an unsafe condition for certain Airbus SAS Model A350-941 airplanes.
The FAA issued a notice of proposed rulemaking (NPRM) to amend 14 CFR part 39 by adding an AD that would apply to certain Airbus SAS Model A350-941 airplanes. The NPRM published in the Federal Register on August 4, 2020 (85 FR 47122). The NPRM was prompted by a report that during the assembly of the section 19 skin to frame (FR) 98 joint of the fuselage, the gaps found on self-aligning nuts for eight fasteners were out of tolerance. The NPRM proposed to require a rotating probe test of all fastener holes located in the affected area for any discrepancies, an eddy current inspection of the surrounding flange for any discrepancies, a detailed inspection of certain frames for any discrepancies, and corrective actions if necessary, as specified in an EASA AD.
The FAA is issuing this AD to address gaps that are out of tolerance, which could reduce the fatigue and damage tolerance properties of the affected area, and possibly affect the structural integrity of the rear cone of the fuselage. See the MCAI for additional background information.
More News
Homing [ICAO] The procedure of using the direction-finding equipment of one radio station with the emission of another radio station, where at least one of the stations is mobile, >[...]
Aero Linx: European Regions Airline Association (ERA) The European Regions Airline Association (ERA) represents a diverse membership of over 50 airlines and more than 150 associate>[...]
A Few Questions AND Answers To Help You Get MORE Out of ANN! 1) I forgot my password. How do I find it? 1) Easy... click here and give us your e-mail address--we'll send it to you >[...]
While On Short Final, About 300 Ft, The Pilot Performed A Forced Landing Near Trees On September 7, 2025, about 0932 eastern daylight time, a CubCrafters Carbon Cub EX airplane, N4>[...]
Severe Icing The rate of ice accumulation is such that ice protection systems fail to remove the accumulation of ice and ice accumulates in locations not normally prone to icing, s>[...]
ANN's Daily Aero-Term (10.13.25): Homing [ICAO]
See All