NTSB Final Report: Vashon Aircraft Ranger R7 | Aero-News Network
Aero-News Network
RSS icon RSS feed
podcast icon MP3 podcast
Subscribe Aero-News e-mail Newsletter Subscribe

Airborne Unlimited -- Most Recent Daily Episodes

Episode Date

Airborne-Monday

Airborne-Tuesday

Airborne-Wednesday Airborne-Thursday

Airborne-Friday

Airborne On YouTube

Airborne-Unlimited-07.14.25

Airborne-NextGen-07.15.25

AirborneUnlimited-07.16.25

Airborne-FlightTraining-07.17.25

AirborneUnlimited-07.11.25

Tue, Jul 16, 2024

NTSB Final Report: Vashon Aircraft Ranger R7

Failure Of The Landing Gear Due To Material Deficiencies That Reduced The Strength Of The Landing Gear

Location: Glendale, Arizona Accident Number: WPR22LA357
Date & Time: September 27, 2022, 14:58 Local Registration: N151VR
Aircraft: Vashon Aircraft Ranger R7 Aircraft Damage: Substantial
Defining Event: Sys/Comp malf/fail (non-power) Injuries: 1 None
Flight Conducted Under: Part 91: General aviation - Personal

Analysis: According to the pilot, when the airplane reached 15-20 knots (kts) during the initial takeoff roll, the left main landing gear collapsed, and the airplane ground looped to the left. The airplane sustained substantial damage to the left elevator and left wing. 

Examination of the left main landing gear (MLG) leg determined it fractured due to preexisting cracks that initiated at the inboard side of the leg at the forward and aft sides of the forward hole for attaching the leg to the fuselage at the outboard attachment bracket. Examination of the crack revealed it existed before the accident flight; however, spacing between crack arrest features suggest the number of load cycles from initiation to failure was relatively low. 

A review of available flight data did not reveal a specific hard landing event that could have resulted in the initiation of the crack. The airplane’s main landing gear is made from a woven E-glass with epoxy resin and prepreg laminate that is pressed and then oven cured. The raw material is not aviation specific. Destructive testing of the failed landing gear and material samples from other gear manufactured from the same lot of material found the material did not meet minimum specified strength requirements. The material batch in question was traceable to 16 airplanes (30 gear legs), including 1 other airplane that had a similar failure following a hard landing. The owners of the affected airplanes were notified and the landing gear for some of the affected airplanes were replaced. Following this accident, the airplane manufacturer initiated a redesign of the landing gear and began performing destructive batch sample tests of the composite material used for every batch of gear legs to ensure each new gear leg meets minimum required strength requirements.

The accident is consistent with the landing gear being manufactured using material that did not meet the necessary strength requirements and subsequently failing after a crack developed in the landing gear. The event that initiated the crack was not identified based on available evidence.

Probable Cause and Findings: The National Transportation Safety Board determines the probable cause(s) of this accident to be -- Failure of the landing gear due to material deficiencies that reduced the strength of the landing gear. 

FMI: www.ntsb.gov

Advertisement

More News

ANN's Daily Aero-Term (07.15.25): Charted Visual Flight Procedure Approach

Charted Visual Flight Procedure Approach An approach conducted while operating on an instrument flight rules (IFR) flight plan which authorizes the pilot of an aircraft to proceed >[...]

Aero-News: Quote of the Day (07.15.25)

“When l became the Secretary of Defense, I committed to rebuild our military to match threats to capabilities. Drones are the biggest battlefield innovation in a generation, >[...]

ANN's Daily Aero-Linx (07.15.25)

Aero Linx: Stearman Restorers Association Welcome to the Stearman Restorers Association. The Stearman Restorers Association is an independent “Not for Profit” 501C-3 Co>[...]

NTSB Final Report: Kjelsrud Gary Kitfox

Airplane Exhibited A Partial Loss Of Engine Power When It Was About Halfway Down The Runway Analysis: The pilot of the experimental amateur-built airplane was departing from his pr>[...]

NTSB Prelim: Cessna A150L

The Flight Path Was Consistent With Low-Altitude Maneuvering On June 18, 2025, about 0922 mountain standard time, a Cessna A150L airplane, N6436F, was substantially damaged when it>[...]

blog comments powered by Disqus



Advertisement

Advertisement

Podcasts

Advertisement

© 2007 - 2025 Web Development & Design by Pauli Systems, LC