NTSB Final Report: RANS S-21 Aircraft | Aero-News Network
Aero-News Network
RSS icon RSS feed
podcast icon MP3 podcast
Subscribe Aero-News e-mail Newsletter Subscribe

Airborne Unlimited -- Most Recent Daily Episodes

Episode Date

Airborne-Monday

Airborne-Tuesday

Airborne-Wednesday Airborne-Thursday

Airborne-Friday

Airborne On YouTube

Airborne-Unlimited-08.25.25

Airborne-NextGen-08.26.25

AirborneUnlimited-08.27.25

Airborne-AffordableFlyers-08.28.25

AirborneUnlimited-08.22.25

Sat, May 18, 2024

NTSB Final Report: RANS S-21 Aircraft

Postaccident Examination Of The Engine Revealed That The Crankshaft Was Fractured At A Crank Cheek

Location: Creswell, Oregon Accident Number: WPR23LA184
Date & Time: May 9, 2023, 17:50 Local Registration: N468MM
Aircraft: RANS S-21 Aircraft Damage: Substantial
Defining Event: Loss of engine power (total) Injuries: 1 None
Flight Conducted Under: Part 91: General aviation - Personal

Analysis: The pilot had recently finished building the airplane and it had amassed about 55 hours of flight time on the airframe and engine (A UL Power Engine--Ed). While the pilot was maneuvering at about 700-900 feet above ground level (agl), the engine made “rough” sounds and vibrated. About 20 seconds later the propeller seized and the pilot made a forced landing in the field below.

A postaccident examination of the engine revealed that the crankshaft was fractured at a crank cheek, just aft of the journal of the No. 2 connecting rod. A materials analysis revealed that the crankshaft fracture resulted from fatigue cracks originating at the surface of the aft radius on the No. 2 rod journal, likely due to high operating stresses on the fillet radii. The metallic particles in oil filters suggested continuous wear on the bearing shells. The worn bearing shells most likely intensified the high operating stress in the crankshaft.

The source of the high operating stress acting on the crankshaft and severe wear of the bearings was not determined, but some out of range operating parameters recorded on the Engine Control Unit (ECU) could have contributed or been the source of these stresses, which led to fatigue cracks and severe wear of the bearing shells. Torque for the propeller flange was not measured, but the bolt, though not difficult to remove, likely lost preload torque due to the propeller striking the ground. There was no evidence that the crankshaft failure was a result of a material flaw or defect, and there is no discernible pattern, or recurring failures observed in the six-cylinder  engine crankshafts.

Probable Cause and Findings: The National Transportation Safety Board determines the probable cause(s) of this accident to be -- A total loss of engine power caused by fatigue cracking and fracture of the crankshaft due to severe wear of the bearings.

FMI: www.ntsb.gov

Advertisement

More News

ANN's Daily Aero-Linx (08.27.25)

Aero Linx: The American Society of Aerospace Medicine Specialists (ASAMS) The Society is a non-profit organization created to serve as a voice for and represent the professional ne>[...]

ANN's Daily Aero-Term (08.27.25): Class C Service

Class C Service This service provides, in addition to basic radar service, approved separation between IFR and VFR aircraft, and sequencing of VFR aircraft, and sequencing of VFR a>[...]

ANN FAQ: Submit a News Story!

Have A Story That NEEDS To Be Featured On Aero-News? Here’s How To Submit A Story To Our Team Some of the greatest new stories ANN has ever covered have been submitted by our>[...]

Airborne-NextGen 08.26.25: Iran UAV Knockoffs, X-37B Spaceplane, Army Training

Also: ERAU Uses UAVs, P550 Group 2 UAS, Starship’s Florida Launches, NASA Missions Chopped The Air Force has put out a call to commission a one-to-one copy of the Iranian-des>[...]

Classic Klyde Morris (08.25.25)

Classic Klyde Morris From 11.07.16 (and Remembering Bob...) FMI: www.klydemorris.com>[...]

blog comments powered by Disqus



Advertisement

Advertisement

Podcasts

Advertisement

© 2007 - 2025 Web Development & Design by Pauli Systems, LC