Wed, Dec 29, 2021
AD 2022-01-04 Prompted By An In-Flight Shutdown (IFSD) Of An Engine
The FAA is adopting a new airworthiness directive (AD) for certain Rolls-Royce Corporation (RRC) AE 2100D3 model turboprop engines.

This AD was prompted by an in-flight shutdown (IFSD) of an engine and subsequent investigation by the manufacturer that revealed a crack in the 3rd-stage compressor wheel. This AD requires replacement of the affected 3rd-stage compressor wheel. The FAA is issuing this AD to address the unsafe condition on these products. This AD is effective February 2, 2022.
Supplementary Information: The FAA issued a notice of proposed rulemaking (NPRM) to amend 14 CFR part 39 by adding an AD that would apply to certain RRC AE 2100D3 model turboprop engines. The NPRM published in the Federal Register on October 12, 2021 (86 FR 56660). The NPRM was prompted by an uncommanded IFSD of a RRC AE 3007A1 model turbofan engine installed on an Embraer S.A. model EMB-145 airplane (marketed as ERJ-145), while conducting a revenue flight.
The manufacturer's investigation of this incident revealed that the IFSD resulted from a low-cycle fatigue crack in the dovetail slot for the blade attachment in the 3rd-stage compressor wheel, causing one 3rd-stage compressor blade to release. The crack initiated in the dovetail slot due to a sharp corner in the wheel slot geometry. The broaching process was identified as the cause of the crack and parts from this manufacturing lot required removal from service.
In response to this event and the manufacturer's subsequent investigation, the FAA issued a final rule; request for comments, AD 2020-16-13 (85 FR 45769, July 30, 2020), requiring replacement of certain 3rd-stage compressor wheels installed on RRC AE 3007A, AE 3007A1, AE 3007A1/1, AE 3007A1/2, AE 3007A1/3, AE 3007A1E, AE 3007A1P, and AE 3007A3 model turbofan engines before the 3rd-stage compressor wheels accumulate a specified number of cycles. The actions required by AD 2020-16-13 address engines that experienced high stresses at the 3rd-stage compressor wheel location and accumulated cycles at a high rate. In the NPRM, the FAA proposed to require replacement of certain AE 2100D3 3rd-stage compressor wheels that were produced in the same lot as the AE 3007 3rd-stage compressor wheels identified in AD 2020-16-13, before they accumulate a specified number of cycles. The FAA is issuing this AD to address the unsafe condition on these products.
More News
Aero Linx: International Federation of Airworthiness (IFA) We aim to be the most internationally respected independent authority on the subject of Airworthiness. IFA uniquely combi>[...]
Ultrahigh Frequency (UHF) The frequency band between 300 and 3,000 MHz. The bank of radio frequencies used for military air/ground voice communications. In some instances this may >[...]
A Few Questions AND Answers To Help You Get MORE Out of ANN! 1) I forgot my password. How do I find it? 1) Easy... click here and give us your e-mail address--we'll send it to you >[...]
From 2019 (YouTube Edition): Learning To Paint Without Getting Any On Your Hands PPG's Aerospace Coatings Academy is a tool designed to teach everything one needs to know about all>[...]
Also: Sustainable Aircraft Test Put Aside, More Falcon 9 Ops, Wyoming ANG Rescue, Oreo Cookie Into Orbit Joby Aviation has reason to celebrate, recently completing its first full t>[...]