Thu, Aug 12, 2021
AD 2021-16-20 Prohibits Installing The Affected Part Unless It Is Inspected And Installed Per The AD Requirements
The FAA is adopting a new airworthiness directive (AD) for certain PZL Swidnik S.A. Model PZL W-3A helicopters.
This AD requires visually inspecting the bonding on a certain partnumbered fairing installed on a certain part-numbered vibration absorber, improving the bonding if necessary, using improved installation procedures to secure the fairing to the vibration absorber, and removing certain parts from service. This AD also prohibits installing the affected part unless it is inspected and installed per the AD requirements. This AD was prompted by a report of a broken bolt securing the fairing to the vibration absorber that resulted from an incorrect torque value for the nut used to secure the fairing to the vibration absorber. The FAA is issuing this AD to address the unsafe condition on these products. This AD becomes effective August 26, 2021. The FAA must receive comments on this AD by October 12, 2021.
Supplementary Information: EASA, which is the Technical Agent for the Member States of the European Union, has issued EASA AD 2020-0038, dated February 27, 2020 (EASA AD 2020-0038), to correct an unsafe condition for all serial-numbered Wytwórnia Sprzetu Komunikacyjnego (WSK) “PZL-Swidnik” Spólka Akcyjna (S.A.) Model PZL W-3A and PZL W-3AS helicopters. EASA AD 2020-0038 advises that a bolt part number (P/N) 3003A-6-16-3 was found broken on fairing P/N 30.23.015.00.03 installed on vibration absorber P/N 30.23.000.00.04. EASA states further investigations identified that the maintenance instructions detailing how to secure the affected parts did not include the torque value information to tighten the castellated nut P/N 3336A-6. EASA further states that this condition, if not corrected, could lead to detachment of the affected part from the helicopter and its subsequent contact with helicopter stationary or rotary parts, possibly resulting in damage to, and consequent
reduced control of, the helicopter.
Accordingly, EASA AD 2020-0038 requires the use of improved installation instructions to secure the affected fairing to the vibration absorber.
More News
Hold Procedure A predetermined maneuver which keeps aircraft within a specified airspace while awaiting further clearance from air traffic control. Also used during ground operatio>[...]
Altitude Readout An aircraft’s altitude, transmitted via the Mode C transponder feature, that is visually displayed in 100-foot increments on a radar scope having readout cap>[...]
Aero Linx: European Hang Gliding and Paragliding Union (EHPU) The general aim of the EHPU is to promote and protect hang gliding and paragliding in Europe. In order to achieve this>[...]
Also: Skydio Chief, Uncle Sam Sues, Dash 7 magniX, OR UAS Accelerator US Secretary of the Air Force Frank Kendall was given a turn around the patch in the 'X-62A Variable In-flight>[...]
"The need for innovation at speed and scale is greater than ever. The X-62A VISTA is a crucial platform in our efforts to develop, test and integrate AI, as well as to establish AI>[...]