Fri, Nov 15, 2013
Hersman: Proposed Rule Goes Beyond The Board's Recommendations Following Investigations
NTSB Chair Deborah A.P. Hersman has written a letter to the U.S. Department of Transportation saying its NPRM for an AD covering thousands of ECi cylinder assemblies goes well beyond the Board's recommendations for inspecting and replacing the cylinders.
In the letter, Hersman said that the Board has worked with ECi and the FAA for many years concerning failures of cylinder assemblies installed on reciprocating aircraft engines. After much research into the failure modes and root causes for certain cylinder head separations on ECi-manufactured cylinder assemblies installed on CMI 520 and 550 series engines, the NTSB issued Safety Recommendation A-12-7 to the FAA on February 24, 2012.
In that recommendation, the Board said that the FAA should:
"Require repetitive inspection of Engine Components, Inc., cylinder assemblies produced between May 2003 and October 2009 (serial numbers 7709 through 52884) installed on Teledyne Continental Motors model 520 and 550 engines and removal of these cylinder assemblies once they reach the engine manufacturer’s recommended normal time (hours) in service between overhauls. (A-12-7)."
"This recommendation was issued to address findings from our investigations and data supplied by ECi in which fatigue cracking of an ECi aluminum cylinder head had initiated in the root of a thread and propagated outward to the point where a majority of the cylinder head separated from a minor portion that remained attached to the cylinder barrel," Hersman wrote. "This head separation causes a significant drop in engine power and possibly engine failure. Repetitive inspection of the cylinder assemblies to detect fatigue cracks before they become critical in size ensures an adequate level of safety for the operator. The proposed rule outlines a failure mode where fatigue cracking initiates between cooling fins and propagates inward to the internal dome radius of the cylinder head resulting in head separation. The NTSB has investigated one case involving internal cylinder head dome cracks in four of six cylinders from an engine1 but has not documented any head separations from such cracking. The NTSB
has not investigated any cases involving engines with cylinder serial numbers ranging from S/N 1 through S/N 1043, nor did concerns about this group of cylinders arise during meetings between the NTSB, the FAA, and ECi to discuss findings related to cylinders within the Group A population."
Hersman said that the proposed AD "would affect many more cylinder assemblies than the NTSB included in our recommendation letter. Because we are not aware of information to support the expanded scope and decrease in compliance time contained in the FAA’s proposed AD, we support FAA action more consistent with NTSB Safety Recommendation A-12-7. If there is additional data to warrant expanding the scope, we encourage the FAA to provide that data and information supporting an expanded scope and compliance time changes in this proposed action.
More News
Aero Linx: Model Aeronautical Association of Australia MAAA clubs are about fun flying, camaraderie and community. For over 75 years, the MAAA has been Australia’s largest fl>[...]
Touchdown Zone Lighting Two rows of transverse light bars located symmetrically about the runway centerline normally at 100 foot intervals. The basic system extends 3,000 feet alon>[...]
“Discovery and innovation are central to our mission at Virgin Galactic. We’re excited to build on our successful record of facilitating scientific experiments in subor>[...]
How To Get A Story On Aero-TV News/Feature Programming How do I submit a story idea or lead to Aero-TV? If you would like to submit a story idea or lead, please contact Jim Campbel>[...]
Student Pilot Reported That During Rotation, “All Of A Sudden The Back Of The Plane Kicked To The Right..." Analysis: The student pilot reported that during rotation, “>[...]