Thu, Apr 07, 2005
But Rollout Delayed Because Of... Yikes... External Tank Foam
Problems
The space shuttle
Discovery is standing tall on Pad 39A at the Kennedy Space Center
in Florida, after a 10 hour 30 minute journey from the Vehicle
Assembly Center that was delayed by the discovery of a crack in the
insulation surrounding the space plane's external fuel tank.
It was a reminder of the insulation foam that fell from
Columbia's external fuel tank as the nation's oldest shuttle
blasted into space for the last time January 16th, 2003. Damage
caused by that chunk of foam led to Columbia's disintegration as it
re-entered Earth's atmosphere February 1st, 2003. All seven
astronauts on board were lost.
The remaining shuttle fleet has been grounded since then, as
NASA worked to refit the space planes according to safety
recommendations made by the Columbia Accident Investigation
Board.
"It's a very, very tiny crack," Launch Director Mike Leinbach
told the Washington Post. "Very, very narrow ... well within our
experience base. It was an acceptable condition for flight, so we
rolled on out and we're going to fly with it just as it is."
Leinbach said the crack was located high up on the tank, in an area
that makes it unlikely to cause any damage to the orbiter
itself.
"It's a great sight to see Discovery rolling out to the launch
pad," said shuttle commander Eileen Collins, watching the
one-mile an hour procession to the pad from her vantage point at
the Johnson Space Center in Houston. Collins will lead the crew on
the next mission. "We know we are getting close."
More News
Airport Marking Aids Markings used on runway and taxiway surfaces to identify a specific runway, a runway threshold, a centerline, a hold line, etc. A runway should be marked in ac>[...]
"It is extremely difficult, if not impossible, for manned aircraft to see a drone while conducting crop-enhancing and other aerial applications at low altitudes and high speeds. We>[...]
Aero Linx: The Skyhawk Association The Skyhawk Association is a non-profit organization founded by former Skyhawk Pilots which is open to anyone with an affinity for the A-4 Skyhaw>[...]
“The T-54A benefits from an active Beechcraft King Air assembly line in Wichita, Kansas, where all required METS avionics and interior modifications are installed on the line>[...]
Aero Linx: Aerostar Owners Association The Association offers the Aerostar Owner a unique opportunity to tap an invaluable source of information concerning the care and feeding of >[...]