Sun, Jul 19, 2009
Accomplished Warbird Pilot Lost In Aerobatic Practice
The NTSB has filed the
first concrete details in the investigation into the fatal accident
that claimed SNJ pilot and airshow flyer, Gary Miller. Miller was
an ATP who had been flying since 14 years of age and was taught to
fly by his Dad. He had over 800 hours in the SNJ/T-6 and some 2500
hours total time. Most recently, he made a living in aviation sales
and as a corporate pilot. He was Reno race qualified and had raced
for several years. He also was an ICAS member with a low-level
aerobatic waiver.
NTSB Identification: CEN09FA425
14 CFR Part 91: General Aviation
Accident occurred Thursday, July 09, 2009 in Simila, CO
Aircraft: NORTH AMERICAN SNJ-5, registration: N212TC
Injuries: 1 Fatal.
This is preliminary information, subject to change, and may
contain errors. Any errors in this report will be corrected when
the final report has been completed.
On July 9, 2009, about 1255 mountain daylight time, a North
American SNJ-5 model airplane, N212TC, was destroyed following
impact with terrain near Simla, Colorado. The airline transport
pilot was fatally injured. The flight was being conducted under the
provisions of Title 14 Code of Federal Regulations Part 91. Visual
meteorological conditions prevailed at the time of the
accident.
Four witnesses observed the airplane performing aerobatic
maneuvers for approximately 15 minutes. They could not estimate how
high the airplane was flying, but indicated it was too high to make
out details on the airplane. They observed the airplane pull up
vertical and perform a wing over or roll type maneuver. The
airplane then entered a spin, which continued until the airplane
impacted the ground. A post impact fire erupted immediately after
impact.
Examination of the airplane showed the fuselage from the leading
edge of the horizontal stabilizer forward to the engine firewall
mostly consumed by fire. The inboard half of the left wing and the
inboard four feet of the right wing were mostly consumed by
fire.
All flight control surfaces were present in the wreckage and
flight control cable continuity was verified from all flight
control surfaces to the forward cockpit.
More News
Airbus Racer Demonstrator Makes Inaugural Flight Airbus Helicopters' ambitious Racer demonstrator has achieved its inaugural flight as part of the Clean Sky 2 initiative, a corners>[...]
A little Bit Quieter, Said Testers, But in the End it's Still a DA40 Diamond Aircraft recently completed a little pilot project with Lufthansa Aviation Training, putting a pair of >[...]
Line Up And Wait (LUAW) Used by ATC to inform a pilot to taxi onto the departure runway to line up and wait. It is not authorization for takeoff. It is used when takeoff clearance >[...]
Contributing To The Accident Was The Pilot’s Use Of Methamphetamine... Analysis: The pilot departed on a local flight to perform low-altitude maneuvers in a nearby desert val>[...]
From 2015 (YouTube Version): Overcoming Obstacles To Achieve Their Dreams… At EAA AirVenture 2015, FedEx arrived with one of their Airbus freight-hauling aircraft and placed>[...]