Sun, Aug 02, 2020
AD 2020-16-10 Requires Removing Comfort Clips From Service And Inspecting The Seat Belt Shoulder Harness
The FAA is adopting a new airworthiness directive (AD) for certain Bell Textron Inc. (Bell) Model 204B, 205A, 205A-1, 205B, 212, 214B, 214B-1, 412, 412CF, and 412EP helicopters.
This AD was prompted by a report of a shoulder harness seat belt comfort clip (comfort clip) interfering with the seat belt inertia reel. This AD requires removing comfort clips from service and inspecting the seat belt shoulder harness (harness) for a rip or an abrasion. The actions of this AD are intended to address an unsafe condition on these products. This AD is effective September 3, 2020.
Supplementary Information: The FAA issued a notice of proposed rulemaking (NPRM) to amend 14 CFR part 39 by adding an AD that would apply to Bell Model 204B, 205A, 205A-1, 205B, 212, 214B, 214B-1, 412, 412CF, and 412EP helicopters with a comfort clip part number (P/N) D7LZ-6560286-A, D7LZ-6560286-B, or 504636-401 installed. The NPRM published in the Federal Register on April 6, 2020 (85 FR, 19113). The NPRM was prompted by a series of service bulletins issued by Bell reporting an issue with comfort clip P/Ns D7LZ-6560286-A, D7LZ-6560286-B, and 504636-401, which are installed on seat belt assemblies. A design review by Leonardo S.p.A. Helicopter (formerly Agusta S.p.A., Finmeccanica S.p.A.) indicates the use of the affected comfort clips could jeopardize, in cases of impact or deceleration, the correct functionality of the seat belt or the seat belt inertia reel. The NPRM proposed to require removing comfort clips P/Ns D7LZ-6560286-A, D7LZ-6560286-B, and 504636-401from service and inspecting each
harness for a rip or an abrasion. The FAA is issuing this AD to address the unsafe condition on these products.
More News
With Testing Soon Complete, Launch Preparations Begin in Earnest Sierra Space's Dream Chaser has been put through the wringer at NASA's Glenn Armstrong Test Facility in Ohio, but w>[...]
Takeoff Roll The process whereby an aircraft is aligned with the runway centerline and the aircraft is moving with the intent to take off. For helicopters, this pertains to the act>[...]
“We’re proud of the hard work that went into receiving this validation, and it will be a welcome relief to our customers in the European Union. We couldn’t be mor>[...]
"Aircraft Spruce is pleased to announce the acquisition of the parts distribution operations of Wag-Aero. Wag-Aero was founded in the 1960’s by Dick and Bobbie Wagner in the >[...]
IDENT Feature The special feature in the Air Traffic Control Radar Beacon System (ATCRBS) equipment. It is used to immediately distinguish one displayed beacon target from other be>[...]