Sat, Aug 07, 2004
AD/PA-44/19 Control
Wheel Attachment 10/2004 DM
Applicability: Group A
aircraft:
Models Serial Numbers
Group B aircraft:
Requirement: 1. For aircraft listed in Group A
of the applicability part of this Directive, with the exception of
aircraft listed in Group A that are already modified in accordance
with the New Piper Aircraft Service Bulletin (SB) No. 1139, dated
28 August 2003; accomplish the following in accordance with Part I
of SB No.1139 dated 9 April 2004:
a. Inspect the control wheel attachment screw for proper thread
engagement
(minimum one thread showing past the end of the nut plate), and
replace the
screw before further flight if insufficient thread engagement is
found.
b. Inspect the nut plate for sufficient locking characteristics.
If the screw can
be fully inserted into the nut plate by hand (one thread showing
past end of
nut), then replacement of the nut plate is required before further
flight.
c. Reassemble the control wheel onto the control wheel shaft and
install the
attachment screw using Loctite thread-locking compound.
2. For aircraft listed in Group A or Group B of the
applicability part of this Directive, install retainer clip part
number 104687-002 in accordance with Part II of SB No. 1139A, dated
9 April 2004.
Note: FAA AD 2004-14-12 Amdt 39-13721
refers.
Compliance:
- Within 25 hours time in service after 11 August 2004.
- Within 100 hours time in service after 11 August 2004.
This Airworthiness Directive becomes effective on 11 August
2004.
Background: The FAA received a report that a
Model PA-28-181 aircraft crashed after the pilot lost control of
the ailerons and elevator. Investigation revealed that the left
control wheel single attachment screw had unscrewed from its nut
plate, which resulted in the control wheel spinning freely on the
control column. Further investigation revealed the screw was too
short and the nut plate lacked proper locking characteristics.
More News
With Testing Soon Complete, Launch Preparations Begin in Earnest Sierra Space's Dream Chaser has been put through the wringer at NASA's Glenn Armstrong Test Facility in Ohio, but w>[...]
Takeoff Roll The process whereby an aircraft is aligned with the runway centerline and the aircraft is moving with the intent to take off. For helicopters, this pertains to the act>[...]
“We’re proud of the hard work that went into receiving this validation, and it will be a welcome relief to our customers in the European Union. We couldn’t be mor>[...]
"Aircraft Spruce is pleased to announce the acquisition of the parts distribution operations of Wag-Aero. Wag-Aero was founded in the 1960’s by Dick and Bobbie Wagner in the >[...]
IDENT Feature The special feature in the Air Traffic Control Radar Beacon System (ATCRBS) equipment. It is used to immediately distinguish one displayed beacon target from other be>[...]
Sierra Space Repositions Dream Chaser for First Mission
See All