Restoration Of Twin Mustang Progressing In Douglas, GA | Aero-News Network
Aero-News Network
RSS icon RSS feed
podcast icon MP3 podcast
Subscribe Aero-News e-mail Newsletter Subscribe

Airborne Unlimited -- Most Recent Daily Episodes

Episode Date

Airborne-Monday

Airborne-Tuesday

Airborne-Wednesday Airborne-Thursday

Airborne-Friday

Airborne On YouTube

Airborne-Unlimited-05.13.24

Airborne-NextGen-05.07.24

Airborne-Unlimited-05.08.24 Airborne-FlightTraining-05.09.24

Airborne-Unlimited-05.10.24

Tue, Jun 06, 2017

Restoration Of Twin Mustang Progressing In Douglas, GA

Team Is Currently Testing Electrical Circuits Preparing For Return To Flight

A rare XP-82 Twin Mustang being restored by a team led by Tom Reilly in Douglas, GA is moving closer to a return to flight.

Warbird News posted an update from the team on its website last week. According to Reilly, the team is finishing work on testing each electrical circuit. The process is a complicated one because each cockpit of the airplane has full controls, and the pilots had the ability to switch all electrical controls back and forth between cockpits. Every system, from boost pumps and lighting to electronic mixture controls, bombs, rockets and guns could be operated from either cockpit. The redundancy was necessary in part because the airplane could fly unrefueled for more than 12 hours, and the pilots could take breaks during extremely long flights.

Warbird News reports that Reilly has finally located the last two electrical components needed to restore the radio installations to their original condition.

Meanwhile, work is also continuing on the exterior of the airplane, including English-wheeling the fuselage-to-center section and the wing trailing edge and wing fairings, as well as tack riveting the cowling prior to spot welding.

The team says that testing on the hydraulic system for landing gear and flaps should be wrapped up at the end of this month. And the final rigging of the primary flight controls for the elevator and rudder is completed, along with trim tab systems. Rigging for the wings will take place once the wings are fully attached to the fuselage.

(Image from file)

FMI: Original Report

Advertisement

More News

Sierra Space Repositions Dream Chaser for First Mission

With Testing Soon Complete, Launch Preparations Begin in Earnest Sierra Space's Dream Chaser has been put through the wringer at NASA's Glenn Armstrong Test Facility in Ohio, but w>[...]

ANN's Daily Aero-Term (05.10.24): Takeoff Roll

Takeoff Roll The process whereby an aircraft is aligned with the runway centerline and the aircraft is moving with the intent to take off. For helicopters, this pertains to the act>[...]

Aero-News: Quote of the Day (05.10.24)

“We’re proud of the hard work that went into receiving this validation, and it will be a welcome relief to our customers in the European Union. We couldn’t be mor>[...]

Aero-News: Quote of the Day (05.11.24)

"Aircraft Spruce is pleased to announce the acquisition of the parts distribution operations of Wag-Aero. Wag-Aero was founded in the 1960’s by Dick and Bobbie Wagner in the >[...]

ANN's Daily Aero-Term (05.11.24): IDENT Feature

IDENT Feature The special feature in the Air Traffic Control Radar Beacon System (ATCRBS) equipment. It is used to immediately distinguish one displayed beacon target from other be>[...]

blog comments powered by Disqus



Advertisement

Advertisement

Podcasts

Advertisement

© 2007 - 2024 Web Development & Design by Pauli Systems, LC