NTSB Prelim: Cessna 150A | Aero-News Network
Aero-News Network
RSS icon RSS feed
podcast icon MP3 podcast
Subscribe Aero-News e-mail Newsletter Subscribe

Airborne Unlimited -- Most Recent Daily Episodes

Episode Date

Airborne-Monday

Airborne-Tuesday

Airborne-Wednesday Airborne-Thursday

Airborne-Friday

Airborne On YouTube

Airborne-Unlimited-05.13.24

Airborne-NextGen-05.07.24

Airborne-Unlimited-05.08.24 Airborne-FlightTraining-05.09.24

Airborne-Unlimited-05.10.24

Mon, Jan 16, 2023

NTSB Prelim: Cessna 150A

(Pilot) Heard What He Described As A “Bang” And Made A Left 180° Turn

Location: Santa Monica, CA Accident Number: WPR23FA073
Date & Time: December 22, 2022, Local Registration: N7032X
Aircraft: Cessna 150A Injuries: 1 Fatal, 1 Minor
Flight Conducted Under: Part 91: General aviation - Personal

On December 22, 2022, about 1518 Pacific standard time, a Cessna 150, N7032X, sustained substantial damage when it was involved in an accident in Santa Monica, California. The pilot sustained minor injuries and the passenger was fatally injured. The airplane was operated as a Title 14 Code of Federal Regulations Part 91 personal flight.

The pilot reported that the accident flight was to be a local flight, heading northwest along the Pacific Ocean coastline with his passenger. Based at Santa Monica Airport, in Santa Monica, California (SMO), the pilot reported that after topping off the fuel tanks, the airplane felt sluggish during the taxi to runway 21. The pilot canceled his takeoff request and taxied to his hangar to troubleshoot the sluggish anomaly. Initially he believed that the sluggish movement was attributed to low tire pressure, so he ensured that the correct pressure was obtained and subsequently initiated an engine start. He reported that again, during taxi to the runup area, the sluggish movement persisted. Upon reaching the engine run-up area, he completed what he referred to as a successful engine run-up and taxied to runway 21, taking off to the southwest.

During the initial climb, about 575 ft above ground level (AGL), the pilot intercepted the coast near Ocean View Park and turned to the right to follow the coastline northwest. Four minutes into the flight, while over Sunset Beach, the airplane had ascended to 1,025 ft AGL with a consistent airspeed of about 70 mph. The pilot reported that he ensured that the carburetor heat was off, that the mixture was rich, that the throttle was in the maximum position, and that the ignition switch was in the Both position. Subsequently, he heard what he described as a “bang” and made a left 180° turn. The pilot contacted the SMO tower controller and attempted to return to SMO. However, the airplane’s descent rate increased, and the pilot initiated a forced landing to the shoreline about 1,500 ft south of the Santa Monica Pier. The airplane touched down heading south, in the shallow water of the shoreline and nosed over.

The airplane wreckage was secured and transported to a facility for further examination.

FMI: www.ntsb.gov

Advertisement

More News

Sierra Space Repositions Dream Chaser for First Mission

With Testing Soon Complete, Launch Preparations Begin in Earnest Sierra Space's Dream Chaser has been put through the wringer at NASA's Glenn Armstrong Test Facility in Ohio, but w>[...]

ANN's Daily Aero-Term (05.10.24): Takeoff Roll

Takeoff Roll The process whereby an aircraft is aligned with the runway centerline and the aircraft is moving with the intent to take off. For helicopters, this pertains to the act>[...]

Aero-News: Quote of the Day (05.10.24)

“We’re proud of the hard work that went into receiving this validation, and it will be a welcome relief to our customers in the European Union. We couldn’t be mor>[...]

Aero-News: Quote of the Day (05.11.24)

"Aircraft Spruce is pleased to announce the acquisition of the parts distribution operations of Wag-Aero. Wag-Aero was founded in the 1960’s by Dick and Bobbie Wagner in the >[...]

ANN's Daily Aero-Term (05.11.24): IDENT Feature

IDENT Feature The special feature in the Air Traffic Control Radar Beacon System (ATCRBS) equipment. It is used to immediately distinguish one displayed beacon target from other be>[...]

blog comments powered by Disqus



Advertisement

Advertisement

Podcasts

Advertisement

© 2007 - 2024 Web Development & Design by Pauli Systems, LC