Tue, Jan 04, 2011
Engineers Analyze Data On All 108 Stringers
Technicians working on space shuttle Discovery's external fuel
tank in the Vehicle Assembly Building at NASA's Kennedy Space
Center in Florida began repairs Monday on three support beams,
called stringers, that recently were detected to have small cracks
on their tops.
Engineers at various NASA centers continue to analyze data from
testing and X-ray type image scans collected during the past week
of all 108 stringers on the outside of the external tank's
intertank section. The image scans showed four small cracks on
three stringers on the opposite side of the tank from Discovery.
Managers decided Thursday to have those cracks repaired in a
similar fashion to repairs made on cracks on two stringers found
after Discovery's Nov. 5 launch attempt.
The repair work is estimated to take 2-3 days. Any further work
will be evaluated thoroughly during the week after additional data
and analysis are reviewed.
Technicians at NASA's Kennedy Space Center in Florida will also
begin modifications to 34 additional stringers on space shuttle
Discovery's external fuel tank on Tuesday. Crews will fit pieces of
metal, called radius blocks, over the tops of the stringers located
at the external tank's thrust panel area to increase the structural
support of the stringers. The thrust panel areas are located at the
attachment points between the tank and the solid rocket boosters,
which see the most stress during the flight into orbit.
The work is expected to take approximately one week. Teams
currently are performing scans on all of the tank's stringers using
a backscatter device, which bounces radiation off the tank allowing
engineers to see below the foam insulation. Engineers at various
NASA centers continue to analyze testing and imaging data. Managers
will meet again Thursday to determine whether radius block
modifications are needed on the remaining stringers.
Discovery Tank Repairs
The next available launch date for Discovery's STS-133 mission
to the International Space Station remains Feb. 3 at the opening of
a window that extends through Feb. 10.
More News
Airport Marking Aids Markings used on runway and taxiway surfaces to identify a specific runway, a runway threshold, a centerline, a hold line, etc. A runway should be marked in ac>[...]
"It is extremely difficult, if not impossible, for manned aircraft to see a drone while conducting crop-enhancing and other aerial applications at low altitudes and high speeds. We>[...]
Aero Linx: The Skyhawk Association The Skyhawk Association is a non-profit organization founded by former Skyhawk Pilots which is open to anyone with an affinity for the A-4 Skyhaw>[...]
“The T-54A benefits from an active Beechcraft King Air assembly line in Wichita, Kansas, where all required METS avionics and interior modifications are installed on the line>[...]
Aero Linx: Aerostar Owners Association The Association offers the Aerostar Owner a unique opportunity to tap an invaluable source of information concerning the care and feeding of >[...]