Mon, Oct 08, 2012
Aero-Terms!
Aero-Terms are designed to be a daily reminder of the terms, names, acronyms and explanations of the unique language that populates the aviation world. Aerospace, sport aviation, fixed wing, helo, you name it... it's all fair game.
Aero-Terms should serve as a quick but intriguing reminder of the terms you may use every day, or an introduction to an aspects of the Aero-World you may not yet be familiar with. ANN also encourages readers to go beyond the FMI link, and further research any intriguing terms.
Suggestions for future Aero-Terms are ALWAYS welcome, as are additions or discussion of the explanations given for each Aero-Term.
Datum
An aircraft datum line is an imaginary vertical plane or line from which all horizontal measurements of arm are taken, generally for balance purposes. Once the datum has been selected, all moment arms and the location of CG range are measured from this point and the weight and balance may be calculated. The datum line appears on drawings as a vertical line, which is perpendicular (90°) to the aircraft horizontal axis. The datum is established by the manufacturer and is referenced in the type certificate data sheet as noted in the attached illustration. There is no fixed rule for the position or location of the datum, except that must be positioned in a location that will not change during the life of the aircraft. For example, if the datum were positioned at the tip of the propeller spinner or the front edge of the a seat it is possible that during the life of the aircraft a new spinner or seat design may be installed thus changing the reference position. So, if the datum position was desired by
the manufacturer to be located in front of the spinner, manufacturer would reference a fixed design spot on the aircraft such as the leading-edge of a wing and specify that the datum position is a set number of inches forward of that point. To avoid confusion, the datum is positioned in such a manner that all reference dimensions will be a positive number rather than a negative number, which would occur forward of that datum position.
More News
Airport Marking Aids Markings used on runway and taxiway surfaces to identify a specific runway, a runway threshold, a centerline, a hold line, etc. A runway should be marked in ac>[...]
"It is extremely difficult, if not impossible, for manned aircraft to see a drone while conducting crop-enhancing and other aerial applications at low altitudes and high speeds. We>[...]
Aero Linx: The Skyhawk Association The Skyhawk Association is a non-profit organization founded by former Skyhawk Pilots which is open to anyone with an affinity for the A-4 Skyhaw>[...]
“The T-54A benefits from an active Beechcraft King Air assembly line in Wichita, Kansas, where all required METS avionics and interior modifications are installed on the line>[...]
Aero Linx: Aerostar Owners Association The Association offers the Aerostar Owner a unique opportunity to tap an invaluable source of information concerning the care and feeding of >[...]