NTSB Prelim: Skybolt Wing Came Apart Before Pilot Hit the Silk | Aero-News Network
Aero-News Network
RSS icon RSS feed
podcast icon MP3 podcast
Subscribe Aero-News e-mail Newsletter Subscribe

Airborne Unlimited -- Most Recent Daily Episodes

Episode Date

Airborne-Monday

Airborne-Tuesday

Airborne-Wednesday Airborne-Thursday

Airborne-Friday

Airborne On YouTube

Airborne-Unlimited-05.13.24

Airborne-NextGen-05.07.24

Airborne-Unlimited-05.08.24 Airborne-FlightTraining-05.09.24

Airborne-Unlimited-05.10.24

Mon, Oct 17, 2011

NTSB Prelim: Skybolt Wing Came Apart Before Pilot Hit the Silk

Structural Failure In-Flight: About As Serious As It Gets...

No one has to tell you that there are a few instances in aviation when the pucker factor is at an all-time high... and a structural failure is pretty close to the top of the list. There is a reason why most aerobats wear a chute (and should)... and that is the result of the more extensive stresses and forces involved in aerobatic flight... and the possibility that a small problem or failure can progress to a much larger one. In this case, the pilot made the solid decision that trying further flight in a compromised airplane was not smart and elected to air out his chute. Smart.

NTSB Identification: WPR11LA459
14 CFR Part 91: General Aviation
Accident occurred Monday, September 19, 2011 in Greenleaf, ID
Aircraft: MCARTHUR STEEN SKYBOLT, registration: N77VW
Injuries: 1 Uninjured.

From The NTSB Prelim: On September 19, 2011, about 1315 mountain daylight time, a McArthur Steen Skybolt, N77VW, collided with terrain following an uncontrolled descent near Greenleaf, Idaho. The pilot was operating the experimental amateur-built airplane under the provisions of Title 14 Code of Federal Regulations (CFR) Part 91. The airline transport pilot was not injured, and the airplane sustained substantial damage during the accident sequence. The local flight departed Caldwell, Idaho, about 1255. Visual meteorological conditions prevailed, and no flight plan had been filed.

The pilot was performing an aerobatic routine in a practice area. He completed the routine uneventfully, and elected to perform it a second time. During the initial dive, he began to level the airplane, and observed the outboard trailing edge section of the upper left wing fail. He observed canvas material in trail from the aft spar, and could not see any wing ribs attached to the spar. He regained partial control of the airplane, but elected to bail out a short time later. The airplane subsequently rolled inverted, and began a near-vertical descent into a field.

FMI: www.ntsb.gov

 


Advertisement

More News

Sierra Space Repositions Dream Chaser for First Mission

With Testing Soon Complete, Launch Preparations Begin in Earnest Sierra Space's Dream Chaser has been put through the wringer at NASA's Glenn Armstrong Test Facility in Ohio, but w>[...]

ANN's Daily Aero-Term (05.10.24): Takeoff Roll

Takeoff Roll The process whereby an aircraft is aligned with the runway centerline and the aircraft is moving with the intent to take off. For helicopters, this pertains to the act>[...]

Aero-News: Quote of the Day (05.10.24)

“We’re proud of the hard work that went into receiving this validation, and it will be a welcome relief to our customers in the European Union. We couldn’t be mor>[...]

Aero-News: Quote of the Day (05.11.24)

"Aircraft Spruce is pleased to announce the acquisition of the parts distribution operations of Wag-Aero. Wag-Aero was founded in the 1960’s by Dick and Bobbie Wagner in the >[...]

ANN's Daily Aero-Term (05.11.24): IDENT Feature

IDENT Feature The special feature in the Air Traffic Control Radar Beacon System (ATCRBS) equipment. It is used to immediately distinguish one displayed beacon target from other be>[...]

blog comments powered by Disqus



Advertisement

Advertisement

Podcasts

Advertisement

© 2007 - 2024 Web Development & Design by Pauli Systems, LC