Tue, Nov 03, 2020
AD 2020-21-23 Describes The Unsafe Condition As Improperly Manufactured Horizontal Stabilizer Rear Attachment Bolts
The FAA is adopting a new airworthiness directive (AD) for Pilatus Aircraft Ltd. Models PC-12, PC-12/45, PC-12/47, and PC-12/47E airplanes.
This AD was prompted by mandatory continuing airworthiness information (MCAI) issued by the aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as improperly manufactured horizontal stabilizer rear attachment bolts. If not corrected, this could lead to fatigue failure of the bolts and loss of airplane control. The FAA is issuing this AD to address the unsafe condition on these products. This AD is effective December 7, 2020.
Supplementary Information: The FAA issued a notice of proposed rulemaking (NPRM) to amend 14 CFR part 39 by adding an AD that would apply to Pilatus Aircraft Ltd. Models PC-12, PC-12/45, PC-12/47, and PC-12/47E airplanes with a certain horizontal stabilizer rear attachment bolt installed. The NPRM published in the Federal Register on August 6, 2020 (85 FR 47716). The NPRM proposed to require replacing the horizontal stabilizer rear attachment bolts and was prompted by MCAI originated by the European Union Aviation Safety Agency (EASA), which is the Technical Agent for the Member States of the European Community. EASA issued AD No. 2019-0129, dated June 6, 2019 (referred to after this as “the MCAI”), to correct the unsafe condition on these products. The MCAI states:
- On the final assembly line, horizontal stabilizer rear attachment bolts were detected that had not received correct heat treatment. Subsequent investigation determined that certain parts, identified by FAUF, were improperly manufactured and consequently have reduced material properties.
- This condition, if not corrected, could lead to a fatigue failure of an affected part, possibly resulting in loss of control of the aeroplane.
- To address this potential unsafe condition, Pilatus issued the [service bulletin] SB to provide inspection and replacement instructions.
- For the reason described above, this [EASA] AD requires replacement of affected parts, and prohibits (re)installation thereof.
You may obtain further information by examining the MCAI in the AD docket on the internet at www.regulations.gov by searching for and locating Docket No. FAA-2020-0745.
More News
With Testing Soon Complete, Launch Preparations Begin in Earnest Sierra Space's Dream Chaser has been put through the wringer at NASA's Glenn Armstrong Test Facility in Ohio, but w>[...]
Takeoff Roll The process whereby an aircraft is aligned with the runway centerline and the aircraft is moving with the intent to take off. For helicopters, this pertains to the act>[...]
“We’re proud of the hard work that went into receiving this validation, and it will be a welcome relief to our customers in the European Union. We couldn’t be mor>[...]
"Aircraft Spruce is pleased to announce the acquisition of the parts distribution operations of Wag-Aero. Wag-Aero was founded in the 1960’s by Dick and Bobbie Wagner in the >[...]
IDENT Feature The special feature in the Air Traffic Control Radar Beacon System (ATCRBS) equipment. It is used to immediately distinguish one displayed beacon target from other be>[...]