AD: CFM International, S.A. Turbofan Engines | Aero-News Network
Aero-News Network
RSS icon RSS feed
podcast icon MP3 podcast
Subscribe Aero-News e-mail Newsletter Subscribe

Airborne Unlimited -- Most Recent Daily Episodes

Episode Date

Airborne-Monday

Airborne-Tuesday

Airborne-Wednesday Airborne-Thursday

Airborne-Friday

Airborne On YouTube

Airborne-Unlimited-05.13.24

Airborne-NextGen-05.07.24

Airborne-Unlimited-05.08.24 Airborne-FlightTraining-05.09.24

Airborne-Unlimited-05.10.24

Wed, May 05, 2021

AD: CFM International, S.A. Turbofan Engines

AD 2021-10-06 Prompted By Multiple Reports Of Pressure Sub-System (PSS) Unit Faults

The FAA is adopting a new airworthiness directive (AD) for certain CFM International, S.A. (CFM) LEAP-1B model turbofan engines.

 This AD was prompted by multiple reports of pressure sub-system (PSS) unit faults due to pressure transducer corrosion following extended storage periods. For an engine in service, this AD requires checks for engine maintenance messages related to the pressure transducer and, depending on the results of the check, replacement of the PSS unit before further flight. The AD requires this repetitive check for faults prior to each flight until the PSS has accumulated at least 15 hours of electrical power. For an engine not in service, this AD requires applying electrical power to the PSS unit before further flight. The FAA is issuing this AD to address the unsafe condition on these products. This AD is effective May 10, 2021.

Supplementary Information: In April 2021, the FAA received a report from CFM, the engine manufacturer, of numerous instances of PSS unit faults. The manufacturer reported these faults have been occurring since October 2020 and are a result of pressure transducer corrosion following extended storage periods. The manufacturer's investigation found that certain PSS units, identified by serial number, have been exposed to conditions that make pressure transducers in these units susceptible to an increased rate of faults. These conditions are moisture ingress from long-term on-wing storage, coupled with certain manufacturing processes of the affected pressure transducers. Together these conditions can cause corrosion and subsequent electrical shorting of the pins in the pressure transducer. This short can result in transmittal of erroneous pressure sensor signals to the electronic engine control. Erroneous pressure input from the pressure transducers in the PSS unit has the potential to prevent engine control from meeting thrust demand, thereby resulting in the loss of engine thrust control. Further, the engine manufacturer found that if transmission of erroneous pressure sensor signals were to occur, it would occur within the first 15 hours of electrical power to the PSS unit after the extended storage period is completed. Therefore, the manufacturer recommended that, for engines with fewer than 15 hours of electrical power applied to the PSS unit within the past 90 days, operators either perform a check for engine maintenance messages related to the pressure transducer prior to each flight or apply electrical power to the PSS unit until the PSS unit has accumulated 15 hours or more of electrical power. The FAA is mandating these recommendations in this AD.

This condition, if not addressed, could result in loss of engine thrust control and reduced control of the airplane. The FAA is issuing this AD to address the unsafe condition on these products.

FMI: www.regulations.gov

Advertisement

More News

Sierra Space Repositions Dream Chaser for First Mission

With Testing Soon Complete, Launch Preparations Begin in Earnest Sierra Space's Dream Chaser has been put through the wringer at NASA's Glenn Armstrong Test Facility in Ohio, but w>[...]

ANN's Daily Aero-Term (05.10.24): Takeoff Roll

Takeoff Roll The process whereby an aircraft is aligned with the runway centerline and the aircraft is moving with the intent to take off. For helicopters, this pertains to the act>[...]

Aero-News: Quote of the Day (05.10.24)

“We’re proud of the hard work that went into receiving this validation, and it will be a welcome relief to our customers in the European Union. We couldn’t be mor>[...]

Aero-News: Quote of the Day (05.11.24)

"Aircraft Spruce is pleased to announce the acquisition of the parts distribution operations of Wag-Aero. Wag-Aero was founded in the 1960’s by Dick and Bobbie Wagner in the >[...]

ANN's Daily Aero-Term (05.11.24): IDENT Feature

IDENT Feature The special feature in the Air Traffic Control Radar Beacon System (ATCRBS) equipment. It is used to immediately distinguish one displayed beacon target from other be>[...]

blog comments powered by Disqus



Advertisement

Advertisement

Podcasts

Advertisement

© 2007 - 2024 Web Development & Design by Pauli Systems, LC