Wed, Feb 21, 2007
Says Engine Marking Procedure Led To Fan Disk Failure
Less than one month after a Mesa
Airlines regional airliner suffered an inflight uncontained fan
disk failure in one of its engines, the FAA has issued an emergency
Airworthiness Directive requiring operators of the type to perform
inspections on their engines.
As Aero-News reported, the
CRJ-200 experienced failure of its number one engine January 25,
approximately 70 nm from Denver International Airport, while
climbing through 24,000 feet. The failure took out the forward
engine cowling, but the aircraft was otherwise unscathed. The
flight returned uneventfully to Denver and none of the 55 persons
aboard was injured.
In its Airworthiness Directive, the FAA states an inspection of
the GE CF34-3B1 engine showed the front section of the engine
failed, resulting in the fan, forward cowlings, and fan reverser
departing from the engine. A subsequent inspection of the recovered
segments of the fan disk, found an electrical arc-out defect at the
fracture origin site.
The FAA adds the fan disk was marked using the electro-chemical
etchmarking (ECM) procedure during engine assembly. If the ECM
procedure is performed incorrectly, an arc-out defect can occur.
This arc-out defect, caused during part marking, resulted in the
uncontained failure.
Operators of affected aircraft may refer to GE Alert Service
Bulletin (ASB) No. CF34-BJ S/B 72-A0213, dated February 15, 2007,
and GE ASB No. CF34-AL S/B 72-A0232, dated February 15, 2007 for
procedures for visual and tactile inspection of certain areas of
certain serial number (SN) fan disks, to determine if those fan
disks are similarly affected.
More News
With Testing Soon Complete, Launch Preparations Begin in Earnest Sierra Space's Dream Chaser has been put through the wringer at NASA's Glenn Armstrong Test Facility in Ohio, but w>[...]
Takeoff Roll The process whereby an aircraft is aligned with the runway centerline and the aircraft is moving with the intent to take off. For helicopters, this pertains to the act>[...]
“We’re proud of the hard work that went into receiving this validation, and it will be a welcome relief to our customers in the European Union. We couldn’t be mor>[...]
"Aircraft Spruce is pleased to announce the acquisition of the parts distribution operations of Wag-Aero. Wag-Aero was founded in the 1960’s by Dick and Bobbie Wagner in the >[...]
IDENT Feature The special feature in the Air Traffic Control Radar Beacon System (ATCRBS) equipment. It is used to immediately distinguish one displayed beacon target from other be>[...]