ANN's Daily Aero-Tips (11.21.06): Land And Hold Short Operations | Aero-News Network
Aero-News Network
RSS icon RSS feed
podcast icon MP3 podcast
Subscribe Aero-News e-mail Newsletter Subscribe

Airborne Unlimited -- Most Recent Daily Episodes

Episode Date

Airborne-Monday

Airborne-Tuesday

Airborne-Wednesday Airborne-Thursday

Airborne-Friday

Airborne On YouTube

Airborne-Unlimited-04.29.24

Airborne-Unlimited-04.23.24

Airborne-Unlimited-04.24.24 Airborne-FltTraining-04.25.24

Airborne-Unlimited-04.26.24

Tue, Nov 21, 2006

ANN's Daily Aero-Tips (11.21.06): Land And Hold Short Operations

Aero-Tips!

A good pilot is always learning -- how many times have you heard this old standard throughout your flying career? There is no truer statement in all of flying (well, with the possible exception of "there are no old, bold pilots.")

Aero-News has called upon the expertise of Thomas P. Turner, master CFI and all-around-good-guy, to bring our readers -- and us -- daily tips to improve our skills as aviators. Some of them, you may have heard before... but for each of us, there will also be something we might never have considered before, or something that didn't "stick" the way it should have the first time we memorized it for the practical test.

Look for our daily Aero-Tips segments, coming each day to you through the Aero-News Network.

Aero-Tips 11.21.06

"November 329 Papa Tango, you're cleared to land runway 19 Right, land and hold short of runway 14."

Evidently someone has been cleared to land or take off from the cross runway. You're job is to land and come to a complete stop before crossing onto Runway 14. If you accept the Land and Hold Short clearance, what exactly are you obligated to do?

LAHSO

Air Traffic Controllers have been directing Land and Hold Short Operations (LAHSO) since 1968. Until July 17, 1997, LAHSOs were conducted to intersecting runways only and that procedure was referred to as Simultaneous Operations on Intersecting Runways (SOIR). Prior to July 17, 1997, there were a few locations that were authorized to land and hold short of a taxiway or approach path.

Occasionally, LAHSO clearances have been refused by the pilot and the refusal has been questioned by the controller. Please remember that the pilot is directly responsible for, and is the final authority concerning, the operation of an aircraft, and depending on several variables, may not be able to accept this type of clearance.

When LAHSOs are expected an announcement will be made on the Automatic Terminal Information System (ATIS). Otherwise pilots shall be advised on initial contact or as soon as practicable thereafter to expect a LAHSO clearance.

Pilot actions

When cleared to land and hold short of an intersecting runway, taxiway or an approach path to a non-intersecting runway, the pilot in command must evaluate his/her ability to touch down and stop before the restriction -- there is no "oops, I landed a little hot" allowed where conflicting traffic is concerned. Then the pilot must either:

  • Accept the clearance, and responsibility to perform as prescribed; or
  • Decline the clearance, informing ATC as soon as possible that you're unable to comply.

Slow to the appropriate landing speed using the optimum flap configuration and braking as necessary to stop in time. If you float or land longer than expected, power up and go around, being careful to safely lift off before the crossing restriction point. If you have any doubt about being able to set down accurately and stop in time, decline the LAHSO clearance.

Aero-tip of the day: Know the very serious responsibility of accepting a LAHSO clearance.

FMI: Aero-Tips

Advertisement

More News

ANN's Daily Aero-Term (04.28.24): Airport Marking Aids

Airport Marking Aids Markings used on runway and taxiway surfaces to identify a specific runway, a runway threshold, a centerline, a hold line, etc. A runway should be marked in ac>[...]

Aero-News: Quote of the Day (04.28.24)

"It is extremely difficult, if not impossible, for manned aircraft to see a drone while conducting crop-enhancing and other aerial applications at low altitudes and high speeds. We>[...]

ANN's Daily Aero-Linx (04.28.24)

Aero Linx: The Skyhawk Association The Skyhawk Association is a non-profit organization founded by former Skyhawk Pilots which is open to anyone with an affinity for the A-4 Skyhaw>[...]

Aero-News: Quote of the Day (04.29.24)

“The T-54A benefits from an active Beechcraft King Air assembly line in Wichita, Kansas, where all required METS avionics and interior modifications are installed on the line>[...]

ANN's Daily Aero-Linx (04.29.24)

Aero Linx: Aerostar Owners Association The Association offers the Aerostar Owner a unique opportunity to tap an invaluable source of information concerning the care and feeding of >[...]

blog comments powered by Disqus



Advertisement

Advertisement

Podcasts

Advertisement

© 2007 - 2024 Web Development & Design by Pauli Systems, LC